Bendix EC-60 UDS 41 / SPN 802 FMI 3 — PMV Common Shorted to Voltage

Code Details

Plain-English Meaning

The EC-60 detected a short to voltage in the common (CMN) supply wire shared by the solenoids in a PMV. Both hold and release solenoids share this wire; a fault here disables all modulation in that valve assembly — ABS at that axle is completely unavailable.

The Bendix EC-60 table maps UDS code 41, blink code 12-08, J1587 093-03, and J1939 SPN 802 FMI 3 to this ABS/ATC/ESP diagnostic entry. The Bendix source indicates an ABS and/or ATC/ESP warning lamp can be on for this entry. The EC-60 continuously monitors wheel speed sensor circuits, pressure modulation valve output drivers, supply voltage quality, J1939 network data from the engine and transmission controllers, and internal self-diagnostic routines. When any monitored value falls outside its acceptable range — or a circuit does not respond as the module expects — the EC-60 logs a diagnostic trouble code and may disable the affected ABS, ATC, or ESP function. Bendix ACOM Pro or a compatible diagnostic interface is the required tool for reading live sensor data, running actuator tests, performing calibrations, clearing latched codes, and adjusting EC-60 configuration parameters. Generic J1939 scan tools can read the SPN/FMI but cannot access EC-60-specific live data screens or configuration settings.

Common Symptoms

• ABS lamp on
• ATC/ESP lamp on if stability functions are affected
• ABS disabled at the affected axle — both hold and release modulation unavailable
• Multiple PMV codes may appear simultaneously for the same axle
• No unusual brake feel under normal pedal pressure; fault only matters during ABS activation

Possible Causes

Possible causes may include the items below. The list is not a parts diagnosis.

• PMV common wire contacted a voltage source — chafed insulation or incorrect connection
• Corroded or loose pin at the PMV connector's common terminal
• Damaged PMV valve body internally shorting the common bus
• Harness damage at a high-flex point near the PMV branch of the axle loom
• Moisture in the PMV connector creating a leakage path

First Checks

• Unplug the PMV connector and measure the CMN pin to ground and to battery voltage — an open, short-to-ground, or short-to-voltage will show immediately.
• Inspect the PMV connector for moisture, corrosion, and terminal condition before condemning the valve.
• Trace the PMV common wire back to the EC-60 harness connector, checking for chafe points near frame rails and axle brackets.
• If the connector and harness are intact, measure valve coil resistance at the PMV connector — a failed valve body can present as a common fault.
• A single PMV CMN fault often triggers additional hold/release codes simultaneously; clear all and recheck after the common wire is repaired.

Can I Keep Driving?

A pressure modulation valve fault means the EC-60 may not be able to independently modulate brake pressure at the affected wheel during ABS activation. Normal brake application still functions, but anti-lock control at that corner is compromised. If the PMV cannot release pressure during a lockup event, wheel lockup may occur despite the ABS system being otherwise functional. Address before operating in conditions requiring aggressive braking.

Related Lookup Pages

• FMI 3 explanation
• Bendix manufacturer hub
• ABS / ATC / ESP fault codes
• ABS Light symptom page
• Brake Warning Light symptom page
• Search this code