Bendix EC-60 UDS 220 / SPN 564 FMI 3 — Diff Lock Solenoid Shorted to Voltage (total shutdown)

Code Details

Plain-English Meaning

The EC-60 detected a short to voltage in the differential lock solenoid circuit. The EC-60 monitors or commands diff lock engagement as part of ATC strategy; a fault here disables the EC-60's ability to request differential lock.

The Bendix EC-60 table maps UDS code 220, blink code 12-13, J1587 102-03, and J1939 SPN 564 FMI 3 to this ABS/ATC/ESP diagnostic entry. The Bendix source indicates an ABS and/or ATC/ESP warning lamp can be on for this entry. The EC-60 continuously monitors wheel speed sensor circuits, pressure modulation valve output drivers, supply voltage quality, J1939 network data from the engine and transmission controllers, and internal self-diagnostic routines. When any monitored value falls outside its acceptable range — or a circuit does not respond as the module expects — the EC-60 logs a diagnostic trouble code and may disable the affected ABS, ATC, or ESP function. Bendix ACOM Pro or a compatible diagnostic interface is the required tool for reading live sensor data, running actuator tests, performing calibrations, clearing latched codes, and adjusting EC-60 configuration parameters. Generic J1939 scan tools can read the SPN/FMI but cannot access EC-60-specific live data screens or configuration settings.

Common Symptoms

• ATC/ESP lamp on
• Differential lock may not engage on command
• ATC function may be partially degraded
• ABS continues normally
• Scan tool shows Bendix EC-60 UDS 220 / SPN 564 FMI 3

Possible Causes

Possible causes may include the items below. The list is not a parts diagnosis.

• Diff lock solenoid wire contacting a voltage source in the harness
• Corroded or damaged diff lock solenoid connector
• Solenoid coil internally shorted or open
• Harness damage from axle housing contact or road debris
• Moisture in the connector creating a leakage path

First Checks

• Unplug the diff lock solenoid connector and measure coil resistance.
• Measure from the solenoid wire to battery voltage to confirm the short.
• Inspect connector for corrosion and damaged terminals.
• Trace harness from solenoid to EC-60 for damage at known flex or abrasion points.
• After repair, clear and verify diff lock engages correctly via ACOM live data.

Can I Keep Driving?

ABS, ATC, and ESP brake-system codes should be handled conservatively. Normal base braking continues when ABS or stability functions are disabled, but the safety benefit of anti-lock and stability intervention is not available. If a brake warning lamp, red stop indicator, loss of braking performance, steering concern, or uncharacteristic vehicle behavior appears alongside this code, stop safely and follow OEM or fleet guidance before continuing.

Related Lookup Pages

• FMI 3 explanation
• Bendix manufacturer hub
• ABS / ATC / ESP fault codes
• ABS Light symptom page
• Brake Warning Light symptom page
• Search this code